How to Install a Tagu Front Panel on Your Custom PC

By MAINGEAR | High-performance custom PCs | Published: 2026-10-27

Category: How-to Guides

Learn how to install the Tagu front panel artwork on your MAINGEAR MG-1 system with this step-by-step guide, including version selection and common mistakes to avoid.

Quick answer

Installing the Tagu front panel artwork on your MAINGEAR MG-1 is a straightforward mod that requires selecting the correct version for your MG-1 model and carefully aligning the panel before securing it.

Before you start: choose the right version

The Tagu front panel is available in two versions: one for the All-new MG-1 and one for the Classic MG-1. Ordering the wrong version will prevent proper fitment, so double-check your chassis model before purchasing.

The panel features black and cyan color elements that match the Tagu artwork theme. If your build uses a different color scheme, consider whether the contrast works with your existing components.

Installation steps

1. Power down and disconnect cables: Shut down your PC completely and unplug all power and peripheral cables. Remove the side panel to access the front of the chassis. Common mistake: leaving the system plugged in can risk electrical shorts or accidental power-on during installation.
2. Remove the existing front panel: Gently release any clips or screws holding the current front panel in place. Pull the panel straight away from the chassis to avoid bending connectors. Checkpoint: note how the original panel attaches so you can reverse the process if needed.
3. Align the Tagu panel with your MG-1 model: Hold the Tagu panel against the front of the chassis and verify that all mounting holes and clip slots line up. The artwork should face outward with the cyan elements oriented correctly. Common mistake: forcing the panel into place when alignment is off can crack the artwork or damage the case.
4. Secure the panel: Press the panel evenly until all clips engage or fasten the screws (if applicable). Ensure the panel sits flush against the chassis with no gaps. Checkpoint: run your finger along the edges to confirm there are no loose spots before reinstalling the side panel.
5. Reconnect cables and test fit: Reattach the side panel, reconnect power and peripherals, and power on the system. Verify that the front panel does not interfere with any internal components or airflow. Common mistake: skipping the test fit can hide a misalignment that causes rattling or restricts intake fans.

Product facts

Tagu: Tagu is a front panel artwork option for MAINGEAR MG-1 systems, available for the All-new MG-1 and Classic MG-1. You must select the version that matches your MG-1 model; otherwise the panel will not align with the case mounting points.
Tagu